Compressor Drive Plate With Overload Protection

Compressor Drive Plate with Overload Protection

- Remove compressor. Refer to => [ Compressor, 4- or 6-Cylinder ] .

Removing

- Remove bolts - A -.





• Use a commercially available band wrench (with webbed band) to counterhold at drive plate - C -.

Installing

- Position drive plate with overload safeguard - B - onto drive plate - C -.

- Insert bolts - A - and tighten them by hand.

- Check run-out of drive plate - B -. Refer to => [ Compressor Drive Plate with Overload Protection, Checking Run-Out and Adjusting ] Compressor Drive Plate With Overload Protection, Checking Run-Out and Adjusting.

- Tighten bolts - A - (tightening torque 10 Nm).

- Check run-out of drive plate - B - again. Refer to => [ Compressor Drive Plate with Overload Protection, Checking Run-Out and Adjusting ] Compressor Drive Plate With Overload Protection, Checking Run-Out and Adjusting.