Power Steering Fluid: Service and Repair

Power steering fluid level, checking
- Do not start engine but bring front wheels to straight-ahead position.

When fluid is cold:
- Remove filler cap.
- Wipe dipstick with a clean cloth.
- Screw filler cap on hand tight and unscrew again.

Note:
^ The cap must be fully screwed on in order to obtain an accurate fluid level reading.





- Check fluid level: The fluid level should be on or around the MIN. marking (up to 2 mm above or below the mark).

Fluid at operating temperature (above approx. 50° C):





- Check fluid level: The fluid level should be between the MIN. and MAX. marks.

Note:
^ Excess fluid must be drained off if the level is above the specified range.
^ If the fluid level is below the range specified, the hydraulic system must be checked for leaks. In this case, it is not sufficient to merely top off the fluid.
^ Do not re-use hydraulic fluid which has been drained off