Rear Lid Lettering

Rear Lid Lettering

Rear Lid Lettering

Dimensional data for front-wheel drive vehicles

• Outer edges of rear lid and lines extending from lower rear lights are used as reference edges.





1 Name plate

• Installation:

- Warm vehicle and type designation to room temperature.

- Bonding surfaces must be dry and free from dust and grease.

- Clean outer panel with mineral spirits, treat with silicone remover and rub dry.

- Pull off backing paper and press on characters, maintaining pressure for approx. 3 seconds.

• - a -= 30 mm.

• - b - = 28 mm.

• - c - = 36 mm.

• - d - = 28 mm.

• - e - = 152 mm.

Dimensional data for All Wheel Drive (AWD) vehicles

• Outer edges of rear lid and lines extending from lower rear lights are used as reference edges.





1 Name plate

• Installation:

- Warm vehicle and type designation to room temperature.

- Bonding surfaces must be dry and free from dust and grease.

- Clean outer panel with mineral spirits, treat with silicone remover and rub dry.

- Pull off backing paper and press on characters, maintaining pressure for approx. 3 seconds.

• - a -= 30 mm.

• - b - = 28 mm.

• - c - = 4 mm.

• - d - = 36 mm.

• - e - = 13 mm.

• - f - = 53 mm.

• Dimensions - g - and - h - only apply to RS 4

• - g - = 68 mm.

• - h - = 18 mm.