Cover and Footrest Bracket

Cover and Footrest Bracket

Special tools, testers and auxiliary items required

• torque wrench (V.A.G 1783)





1 Base Support Cover

• Removing

- Remove lower instrument panel trim on driver side. Refer to => [ Lower Driver Side Instrument Panel Cover ] Lower Driver Side Instrument Panel Cover.

- Remove instrument panel cover. Refer to => [ Instrument Panel Cover, Removing and Installing ] Bar Piece.

- Remove bar piece. Refer to => [ Bar Piece ] Bar Piece.

- Remove hood cable operating lever. Refer to => [ Hood cable operating lever, removing and installing ] Lower A-Pillar Trim.

- Remove the upper B-pillar trim. Refer to => [ Upper B-Pillar Trim ] Upper B-Pillar Trim

- Remove lower B-pillar trim. Refer to => [ Lower B-Pillar Trim ] Lower B-Pillar Trim.

- Remove lower A-pillar trim. Refer to => [ Lower A-Pillar Trim ] Lower A-Pillar Trim.

- Remove the bolt - 8 -.

- Slide base support cover - 1 - upward until tabs - 7 - disengage from base support bracket recess - 4 -.

- Remove base support cover - 1 -.

• Installing

Installation is in reverse order of removal, noting the following:

- Make sure the tab - 7 - locks inside the base support - 4 -.

2 Spring Clamp

3 Driver Side Storage Compartment

4 Base Support Bracket

• Removing

- Remove base support cover - 1 -. Refer to => [ (Item 1) Base Support Cover ]

- Peel floor covering back in base support area.

- Remove nuts - 6 - (quantity: 3).

- Remove base support bracket - 4 -.

• Installing

Installation takes in reverse order of removal.

5 Spring Nut

6 Nuts

Quantity: 3

• Tightening specification 3 Nm

7 Tab

• Joined firmly with base support cover

8 Screw

3 Nm