Seat Rail Cover
Seat Rail Cover
• The procedure for removing and installing is described on the driver seat sill side seat rail cover. The procedure is similar for the tunnel side seat rail cover.
Special tools, testers and auxiliary items required
• Trim Removal Wedge (3409)
Removing
• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Safety Precautions ] Service Precautions.
• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.
- Remove the front seat:
• Standard seat and Sport seat (manual). Refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.
• Standard seat, Sport seat (power) and Comfort seat. Refer to => [ Power Standard Front Seat ] Power Standard Front Seat.
• Super Sport seat. Refer to => [ Super Sport Front Seat ] Super Sport Front Seat.
- Unclip the retaining tabs - 3, 4 and 5 - on the cover - 2 - from the seat rail.
- Remove the cover - 1 - forward parallel to the seat rail.
Installing
• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Safety Precautions ] Service Precautions.
• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.
Install in reverse order of removal. Note the following:
• Make sure the connectors are installed all the way in and are secure.
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.
- Connect the battery ground (GND) cable with the ignition turned on.
• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the vehicle diagnostic tester.