High Beam Bulbs (M30)/(M32)

High Beam Bulbs (M30)/(M32)

Removing






- Turn off the ignition and remove the ignition key.

- Turn the light switch to the "0" position.

- Remove the headlamp. Refer to => [ Headlamp ] Headlamp.

- Remove the high beam bulb cap - 1 - from the headlamp - arrow A -.

- Remove the bulb - 3 - from the spring clips - B arrows -.

- Disconnect the electrical connector - 2 - from the bulb.

Installing

Install in reverse order of removal, observing the following:

- Insert the new bulb into the housing without touching the bulb with bare hands.

- Position the bulb on the lower spring clip.

- Press the bulb into the headlamp past the upper spring clips.

- Connect the connector and close the housing cap.

- Install the headlamp. Refer to => [ Headlamp ] Headlamp.