Low Beam Headlamp Bulb (M29)/(M31)

Low Beam Headlamp Bulb (M29)/(M31)

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

• Headlamps must be adjusted after performing measures that could influence headlamp adjustment. Refer to => [ Headlamps Checking and Adjusting Conditions ] Headlamps Checking and Adjusting Conditions.

Removing






- Remove headlamp. Refer to => [ Headlamps ] Headlamps.

- If equipped, remove the bolt - 2 -.

- Release spring clip - arrow - and remove low beam/daytime running light bulb housing cover - 1 - from headlamp housing.

- Disconnect electrical connector - 3 - on low beam/daytime running light bulb.






- Open the wire clamp - 2 - and remove the bulb - 1 - from the housing.

Installing

• Tightening specification, refer to => [ Halogen Headlamps Overview ] Halogen Headlamps Overview.

Install in reverse order of removal. Note the following:

- Insert the new bulb into the housing without touching the bulb with bare hands.

- Secure the bulb with spring clip.

- Connect the connector and close the housing cover.

- Secure housing cover using wire clamp.

- Install the headlamp. Refer to => [ Headlamps ] Headlamps.