Diagram 53/2 (Tracks 1-14)

IMPORTANT NOTE:
This manufacturer uses "Track" style wiring diagrams.
For information on how to use these diagrams effectively, please refer to Diagram Information and Instructions. Diagram Information and Instructions


All-Wheel Drive Control Module, Haldex Clutch Pump, Fuses





ws = white
sw = black
ro = red
br = brown
gn = green
bl = blue
gr = grey
li = lilac
ge = yellow
or = orange
rs = pink

J492 - All-Wheel Drive Control Module Locations

J533 - Data Bus On Board Diagnostic Interface Component Locations

J623 - Engine Control Module (ECM) Component Locations

J681 - Power Supply Relay 2 (terminal 15) Relay Carrier on Vehicle Electrical System Control Module, from June 2009

SC7 - Fuse 7 (on fuse panel C)

SC8 - Fuse 8 (on fuse panel C)

T6q - 6-Pin Connector, black, on all-wheel drive control module

T8o - 8-Pin Connector, black, on all-wheel drive control module

T20d - 20-Pin Connector, black, on data bus on board diagnostic interface

V181 - Haldex Clutch Pump Locations

(393) - Ground Connection 28 (in main wiring harness)

(662) - Ground Connection (on left rear side panel) Locations

(B163) - Plus Connection 1 (15) (in interior wiring harness)

(B383) - Powertrain CAN-Bus High Connection 1 (in main wiring harness)

(B390) - Powertrain CAN-Bus Low Connection 1 (in main wiring harness)

^ - CAN-Bus (data wire)

* - => Wiring Diagram Engine

** - Where applicable

# - Relay Carrier on Vehicle Electrical System Control Module

Next Diagram 53/3 (Tracks 15-28)