Control Valve Control Unit (J808)

Control Valve Control Unit (J808)

Removing

- Remove the rear engine cover - 2 - upward.






- Disconnect the connector - 3 - from the control valve control module.






- Remove the bolts - 5 and 6 -.

- Remove the bypass connection - 1 - with the adapter - 2 - and control valve control module - 4 -.

Installing

Install in reverse order, paying attention to the following:

• Replace the O-rings.

- Install the bypass connection - 1 - with the adapter - 2 - and control valve control module - 4 -. Use new O-rings.






- Install the bolts - 5 and 6 - hand-tight.

- First tighten the bolts - 6 - to the tightening specification.

• Tightening Specifications: 10 Nm

- Then tighten the bolts - 5 - to the same tightening specification.

- Connect the connector - 3 -.

- After replacing the control valve control module perform an Adaptation in Guided Functions using a vehicle diagnostic tester.