4. "Adjustment EWS - DME Vehicles From 1/95"

NOTE:
After synchronizing an EWS vehicle the ignition must be switched off for at least 10 seconds prior to restart.
This step is used to synchronize an EWS control module with the DME if:

1. The DME control module has been replaced with a pre-programmed DME control module or

2. After programming a basic programmable control module or a replacement EPROM, the message "Programming complete-EWS alignment not carried out" is displayed. Start adjustment EWS-DME Y/N

Refer to TRI 61 01 95 (2144) for complete EWS details.