Sunroof / Moonroof Cable: Service and Repair
REPLACING BOTH SUN ROOF DRIVE CABLESRemove sun roof lid. Service and Repair
Remove motor/gearbox (electric), Service and Repair
or remove gearbox (manual). Service and Repair
Push back drive cables uniformly on both sides.
Remove cover rails.
Installation:
Replace screws.
Tightening torque: 1.8 Nm (1.3 ft. lbs.) or 2.8 Nm (2.0 ft. lbs.) for both rear screws.
Installation:
Pull drive cables forward on both sides.
Arrest drive cable (2) and gate (3) in "0" position with key (1).
Install motor/gearbox unit.
Pull drive cables Out of guide pipes.
Press off linkage (1).
Installation:
Flocked drive cables must NOT be lubricated with grease.
Press drive cable (2) off of gate (1) in middle position.
Drive cable (2) is marked. L =Left, R = Right