Air Cleaner Housing: Service and Repair
Removing and Installing Suction Filter Housing:- Turn and pull off multiple pin connector (1).
- Unfasten screw from active carbon filter lead.
- Loosen hose clamp. Withdraw hoses (3, 4). Pull off gaiter.
- Open (four) clamps.
- Loosen retainers (1). Disconnect connector (2). Unfasten hose clip (3). Remove upper section of intake filter.
- Remove upper section of air-filter housing with air-flow sensor and gaiter.
Installation Note: Secure the lead and cable clips.
- Unscrew nuts.
- Unclip and remove lower section of housing.
Installation Note: Install suction snorkel and install lower section of housing in rubber mount.