Removing and Installing Mounting Block For Pedals

Caution: If a brake pedal without a retaining bracket (which encloses the piston rod) is fitted, if must be replaced by a brake pedal with a retaining bracket.

Remove panel for pedal assembly.
Remove brake pedal.
If necessary, remove clutch switch.
Installation: Make sure plug connections engage correctly.





Unhook return spring from clutch pedal.
Press pin ends together and withdraw pin (2).
Release screws (1) on clutch master cylinder.
Remove retaining plate for brake light and clutch switches.





Release nuts (1) and remove bearing block (2).





Installation: Tighten nuts (1) in front of nut (2).
Bearing pedestal to brake assembly and body 25 Nm