Replacing Front Ride Level Sensor

Replacing Front Ride Level Sensor

Replacing front height setting sensor

Caution:
After assembly, check headlight adjustment.





Remove connector (1).
Unfasten nut (2) and disconnect control rod.
Unfasten screws (3) and remove height setting sensor.

Installation.
Lever (4) points outwards.
Tightening torque:
- Ride level sensor to holder 5 Nm
- Control rod to ride level sensor/holder 8 NM
- Control Rod to swinging arm (Rear) 8 NM
- Bracket ride level sensor to rear axle carrier 8 NM






Release nut (1).

Installation:
The bracket must be located between both cast lugs (2).