Replacing Rear Axle Carrier

33 31 011 - Replacing rear axle carrier





Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off pipe connections with plugs.





Necessary preliminary tasks:
- Remove rear differential Removing and Installing/Replacing Rear Differential
- Remove complete rear axle carrier Removing and Installing Complete Rear Axle Carrier and if necessary with other workers assisting set down on a suitable surface
- Version with Dynamic Drive: Disconnect pressure lines for oscillating motor of rear axle from rear axle carrier
- Remove both stabilizer links from stabilizer Replacing Stabilizer Links for Stabilizer
- Remove stabilizer from rear axle carrier
- Remove ride-height sensor with holder from rear axle carrier Replacing Rear Ride-Height Sensor





Remove swinging arm on both sides from rear axle carrier Removing and Installing/Replacing Left or Right Swinging Arm.
Remove control arm on both sides from rear axle carrier Replacing One Upper Control Arm.
Remove guide arm on both sides from rear axle carrier Replacing a Guide Arm.
Remove wheel carrier on both sides with output shaft, swinging arm and suspension arms.





After installation:
- Version with Dynamic Drive:
- Fill and bleed hydraulic system
- Check pipe connections for leaks
- Adjust handbrake Adjustments
- Perform chassis alignment check
- If necessary, carry out initial Dynamic Drive operation Initial Inspection and Diagnostic Overview