Operation CHARM: Car repair manuals for everyone.
Home >> BMW >> 2004 >> M3 Convertible (E46) L6-3.2L (S54) >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Camshaft Position Sensor >> Service and Repair >> Replacing Pulse Generator on Inlet Camshaft (S54)
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Replacing Pulse Generator on Inlet Camshaft (S54)




Replacing Pulse Generator On Inlet Camshaft (S54)

Special tools required:
- 12 1 120

Turn off ignition.
Remove intake air manifold.
Remove cable strip for fuel injectors with special tool 12 1 120 . This operation is described in the section "Removing and installing a fuel injector".







Release screw on pulse generator (1).
Disconnect pulse generator plug connection on connector strip.
Remove pulse generator (1).

Installation:
Tightening torque, 12 14 3AZ.
Check sealing ring of pulse generator for possible damage, replace if necessary.


NOTE:
Interrogate fault memory of DME control unit.
Check stored fault messages.
Rectify faults.
Then clear fault memory.
pro multis · About Operation CHARM