Engine Control Module: Service and Repair

Replacing Control Module (DME)

Follow instructions for removing and installing electronic control units.

Before replacing the control module, always follow the instructions listed below:
- Code control unit
- Program control unit.


CAUTION: It is absolutely essential to read out the fault memory with the MoDiC or the BMW DIS and to create a fault memory printout.


Turn off ignition.







Release screws (1).
Remove cover.







Installation:
Correctly install wiring harness with grommet in cover (water tightness).
Hook cover (3) into hinges of underside of electronics box (1).
Make sure upper stop (2) is correctly installed above hinges on underside of electronics box.







Assignment of electronics box (with automatic transmission):
1 = Control unit, Digital Motor Electronics (DME)
2 = Control unit for automatic transmission







Disconnect plug connections (1).
Remove control unit (2).

Installation Note: Replacement: Observe equipment no. and coding.


NOTE:
Interrogate fault memory of DME control module.
Check stored fault messages.
Rectify faults.
Then clear fault memory.