Removing and Installing/Replacing Left or Right High-Pressure Nozzle of Headlight Washer System

61 67 083 - Removing and installing / replacing left or right high-pressure nozzle of headlight washer system





Special tools required:
- 13 3 010 13 3 010 Hose Clip






Necessary preliminary tasks:
- Remove cover from spray nozzle 51 11 ... Removing and Installing/Replacing Cover For Headlight Cleaning System on Left
- Remove front wheel arch cover Removing and Installing/Replacing Front Left or Right Wheel Arch Cover (Front Section)





To prevent excessive escape of washer fluid, seal off end of high-pressure line with special tool 13 3 010 13 3 010 Hose Clip.
Catch any escaping washer fluid if necessary.






Note:
Bumper trim shown removed for purposes of clarity.

Unlock catch (1) in direction of arrow.
Feed high-pressure nozzle (2) towards rear out of headlight arm (3).
Unlock plug connection on high-pressure nozzle (2) and detach high-pressure line from high-pressure nozzle (2).






Installation:
Keep plug connection for high-pressure nozzle and high-pressure line clean and free from grease.
Ensure guide (2) is correctly seated.
Retaining lugs (1) must snap audibly into place.
Check function.
If necessary, adjustment can be carried out carefully using pointed pliers (tape of front area with adhesive tape where necessary).
If necessary, top up washer fluid.