Removing and Installing/Replacing ACC Sensor

66 31 006 - Removing and installing (replacing) ACC sensor





Special tools required:
- 00 9 317 00 9 317 Trim Panel Wedge





Unclip trim (1) at points (2) and remove in direction of arrow from bumper trim (3).

Important!
To avoid damaging bumper trim when feeding ACC sensor out, cover area around bumper cutout with suitable adhesive tape.





Installation Note:
Make sure trim (1) is correctly seated.

Locking hooks (2) and retaining element (3) must not be damaged.





Important!
Secure ACC sensor (2) against falling out.

Tape off bumper in working area with adhesive tape (1).

Using special tool 00 9 317 00 9 317 Trim Panel Wedge, unclip ACC sensor (2) from holders on both sides.





Important!
Secure ACC sensor (2) against falling out.

Disconnect plug connection (2) and remove sensor (1).





After installation:

Carry out ACC sensor adjustment Adjustments using BMW diagnostic system.





Replacement:

Carry out rough adjustment of ACC sensor (1).

If necessary, perform rough adjustment at retaining pins (2).

- Measurement A [mm]: 42.5 to 43.5