51 12 ... Replacing Rear Bumper Trim

51 12 ... - Replacing trim on rear bumper (M Technic aerodynamic kit)





Special tools required:






Necessary preliminary tasks:
- Remove rear bumper trim
- Remove bottom middle trim on rear bumper 51 12 ... Replacing Rear Bumper Trim





Carefully heat trim (1) with hot air blower and detach with special tool 00 9 317 from bumper (2).






Installation:
Minimum object temperature of trim and bumper ≥ 18 °C.
If this temperature is not achieved, the components must be preheated.
For cleaning, use a fluff-free disposable cloth or a clean cleaning cloth.
Clean adhesive area of bumper with spirit.
Air drying time at least 1 minute.





Installation:
Trim (1) is positioned over guides (2) on bumper.
Remove liner from trim (1).
Press down trim (1) firmly with back of your hands over entire surface, especially the ends.