Manufacturer Code Charts: 112201

112201 - P0202

Information saved in
DME

Fault code
112201 - P0202

Fault text
Injector, cylinder 2, activation: open circuit

Fault description
The diagnostic function monitors electrical activation of the
injector.

Condition for fault identification
Test condition:
The fault is recognized when the voltage at the injector is >
210 V and the injector's electrical charge is < 300 �As.
Potential problem source(s):
- Defect in wiring harness between DME and injector 2
- Injector 2 defective
Terminal condition: none
Voltage condition:
- Electrical system voltage > 10 V
Temperature condition:
- Coolant temperature > -20 °C
Time condition:
- None
Other conditions:
- Engine on

Condition for fault memory entry
This fault is logged in the control module's fault memory
immediately.

Action in service
- Inspect wiring harness between DME and injector 2
- Check injector 2: Measure the resistance between the pins
for the injectors, (specified: 200 kOhm +/-10 kOhm), if the
specified value is not obtained, replace the injector

Fault effect and breakdown warning
Breakdown notice:
- The engine reverts to its limp-home program, continued
vehicle operation is possible but drivability is restricted,
because power is reduced the driver should refrain from
passing maneuvers.
Possible apparent symptoms:
- Engine runs poorly with power loss

Driver information
Warning light:
- ECE emissions warning lamp: on
- US emissions warning lamp: on
- ECE electronic engine power reduction: on
- US electronic engine power reduction: on
- CC message: on

Service instruction
- none