115601 - P02D7 (DME)

115601 - P02D7

Information saved in
DME

Fault code
115601 - P02D7

Fault text
Cylinder equalization, adaptation, upper range, cylinder 6:
adaptation above valid range

Fault description
The diagnostic function monitors the engine's running
smoothness during the adaptation routine.

Condition for fault identification
Test condition:
The fault is recognized when corresponding running
roughness is present during the adaptation routine.
Potential problem source(s):
- The particular injector is defective
- Low compression on the specific cylinder
- Precatalyst defective but not yet debounced on one bank
Terminal condition: Terminal 15
Voltage condition:
- Electrical system voltage > 10 V
Temperature condition:
- None
Time condition:
- None
Other conditions:
- none

Condition for fault memory entry
This fault is logged in the control module's fault memory
immediately.

Action in service
- Check compression
- Replace the particular injector (if the teflon ring is
defective then there will be apparent carbon accumulation
on he ignition coil near the spark plug)
- Replace precatalyst on the specific bank

Fault effect and breakdown warning
Breakdown notice:
- The engine reverts to its limp-home program, continued
vehicle operation is possible but drivability is restricted,
because power is reduced the driver should refrain from
passing maneuvers.
Possible apparent symptoms:
- Ignition miss and loss of power can occur.

Driver information
Warning light:
- ECE emissions warning lamp: on
- US emissions warning lamp: on
- ECE electronic engine power reduction: off
- US electronic engine power reduction: off
- CC message: none

Service instruction
- none