112702 - P313B (DME)

112702 - P313B

Information saved in
DME

Fault code
112702 - P313B

Fault text
Injector, cylinder 7, activation: short circuit

Fault description
The diagnostic function monitors electrical activation of the
injector.

Condition for fault identification
Test condition:
The fault is recognized when the voltage at the injector is <
50 V and the electrical charge at the injector is > 1200 �As
and the internal current monitoring conditions (current
integral and charging characteristics) are not satisfied
Potential problem source(s):
- Injector 4 and/or 7 defective
Terminal condition: none
Voltage condition:
- Electrical system voltage > 10 V
Temperature condition:
- Coolant temperature > -20 °C
Time condition:
- None
Other conditions:
- Engine on

Condition for fault memory entry
This fault is logged in the control module's fault memory
immediately.

Action in service
- Check injectors 4 and 7: Measure the resistance between
the pins for the injectors, (specified: 200 kOhm +/-10
kOhm), if the specified value is not obtained, replace the
injector

Fault effect and breakdown warning
Breakdown notice:
- The engine reverts to its limp-home program, continued
vehicle operation is possible but drivability is restricted,
because power is reduced the driver should refrain from
passing maneuvers.
Possible apparent symptoms:
- Engine runs poorly with power loss

Driver information
Warning light:
- ECE emissions warning lamp: on
- US emissions warning lamp: on
- ECE electronic engine power reduction: on
- US electronic engine power reduction: on
- CC message: on

Service instruction
- none