37 14 055 Removing and Installing/Replacing Dynamic Drive Control Unit

37 14 055 Removing and installing/replacing DYNAMIC DRIVE control unit





Important!
Read and comply with notes on protection against electrostatic discharge (ESD protection).





Necessary preliminary tasks:
^ Disconnect battery negative cable
^ Remove side cover on instrument panel

Disconnect plug connection (1).

Release screw (2).





Tightening torque 37 14 8AZ.

Remove Dynamic Drive control unit (3) from side.





Installation note:
Insert control unit (1) with tab (2) into corresponding opening in support tube.

Engagement stud (3) must rest correctly in opening of lug (2).





After installation:
^ Replacement only: Carry out programming/encoding
^ Only when replacing / programming / coding: Carry out initial DYNAMIC DRIVE operation.

�=: