33 32 051 Removing and Installing/Replacing Left or Right Push Rod/Integral Link

33 32 051 Removing and installing/replacing left or right push rod/integral link





Note:
If the integral link is detached from the wheel carrier or swinging arm, it is necessary after reinstallation to carry out a wheel/chassis alignment check.





Necessary preliminary tasks:
^ Remove rear wheel
^ Tension coil spring (and leave on vehicle)
^ Version with ride-height control: Deactivate and empty air spring system

Release nut (1) and remove screw.

Release screw (2) and remove integral link (3).





Installation:
Replace self-locking nut.

First install swinging arm hand-tight, then tighten down screw (2).

Tighten screw/bolt connections in normal position.

Tightening torque (nut) 33 32 3AZ.

Tightening torque (bolt) 33 32 4AZ.





After installation:
^ Activate and fill air spring system
^ Perform chassis alignment check