27 10 010 Removing and Installing Transfer Box ATC 700 (Automatic Transmission)

27 10 010 Removing and installing transfer box ATC 700 (automatic transmission)





Important!
After replacement, the "Repair" service function must be carried out with in the BMW diagnosis system.





Important!
After completing work, check gear oil level and top up if necessary.
Filler plug (1):
Tightening torque 27 00 11AZ.
Oil level up to filler edge of filler plug (1).
Use only the approved transmission fluid.

Failure to comply with this requirement will result in serious damage to the transfer box!





Necessary preliminary tasks:
^ Remove underbody protection
^ Remove exhaust system bracket from transmission and transfer box
^ Remove propeller shaft
^ Remove front propeller shaft
^ Support transmission.
^ Remove transmission crossmember.





Disconnect plugs (1) and (2) from servomotor.

Release screw connection of transfer case.

Tightening torque 27 00 9AZ.

Remove transfer case.








Installation note:
Pay attention to dowel pin (1).

Grease dowel pin (1).

Apply a thin coat of grease to splines.

Grease: WEICON ANTI-SEIZE.

Zy: