Component Tests and General Diagnostics

1. If windows only operate from the LH Master Switch, check for approximately B + at LH Master Switch Connector C2 terminal "F".

2. Check that Ground G305 is clean and tight.

3. If all power windows do not operate, check Power Window Circuit Breaker.

4. Before performing any diagnostics, make sure the Lockout Switch is in the "OFF" position (4 Door or Convertible).

^ Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove "GOOD" in a continuity/voltage check.
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems.