Front Door

FRONT DOOR MODULE ASSEMBLY






REMOVAL
1. Lower window 1/2 inch and tape glass to header.
2. Remove trim panel, front and rear trim brackets, and water deflector.
3. Remove two front run channel screws.
4. Disconnect wire connectors from latch and rose buds from panel.
5. Disconnect module lock rods from latch. Cut out and discard lock rod clips from latch.
6. Remove 2 sash nuts.
7. Remove three nuts (one only on LeSabre).
8. Remove module assembly.

INSTALLATION

NOTICE: Crossarms cannot be repaired. If damage occurs to crossarm assembly, replace module.

1. Install new lock rod clips to latch.
2. Load module assembly through access hole.
3. Install module lock rods to latch.
4. Connect wire connectors.
5. Adjust door window.
6. Install speaker, water deflector, front and rear trim bracket and trim panel. Water deflector must adhere well with no wrinkles at bottom.