Universal Garage Door Opener Programming

1. Hold the end of the hand-held transmitter against the bottom of the universal garage door opener. Position (he hand-held transmitter so that the red light is visible,

^ The hand-held transmitter must be held less than one inch from the universal garage door opener.

2. Using two hands, push both the hand-held transmitter button and the desired universal garage door opener button. Do not release the button. Continue to hold both buttons through step three.

3. Hold down both buttons until you see the red tight on the universal garage door opener flash slowly then rapidly. This could take up to one minute or more.

4. Release both buttons after the light flashes rapidly.

^ If the light light does not perform as indicated, or the opener does not function properly, refer to "Universal Garage Door opener Diagnosis TEST K". Testing and Inspection