Transmitter Programming

Important: Before entering the programming mode, verify the posession of all of the transmitters you will be using for the vehicle. Once you program the transmitter, the memory erases. The other transmitters will not be functional until you program the transmitters again. You may program up to 4 transmitters.

Perform the following procedure or use a scan tool when adding new transmitters or replacing failed transmitters:

1. Turn OFF the ignition.
2. Use a fused jumper wire in order to connect the data link connector terminal 8 (BLK/WHT) to terminal 4 (BLK).
3. Close all of the doors.
4. Turn ON the ignition switch.
5. Press and hold the following buttons on one of the transmitters for 30 seconds:
^ LOCK
^ UNLOCK
6. After a 30 second delay, the doors will lock and unlock.

Important: Do not turn OFF the ignition. If the switch is turned OFF, the first transmitter becomes inoperative.

7. In order program extra transmitters, repeat step 5.
8. Disconnect the fused jumper wire from the data link connector (DLC).