Blower Case

Blower Case:

Blower Case Outer Seals:

Remove or Disconnect

1. Body hinge pillar tie bar-cross car beam.
2. Fuel injector sight shield cover. Refer to Engine Cover Replacement Service and Repair.
3. Drain cooling system.
4. Recover refrigerant.
5. A/C lines at evaporator block fitting.
6. Heater hoses at heater core.
7. Blower case to dash nuts.
8. Vacuum hoses.
9. Electrical connectors.
10. Blower case.
11. All outer blower case seals.

Install or Connect

1. All outer blower case seals.
2. Blower case.
3. Electrical connectors.
4. Vacuum hoses.
5. Blower case to dash nuts.

Tighten
^ Nuts to 10 N.m (89 lb. in.).

6. Heater hoses at heater core.
7. A/C lines at evaporator block fitting.

Tighten
^ Bolt to 16 N.m (12 lb. ft.).

8. Evacuate, recharge, and leak test system.
9. Fill coolant system and check for leaks. 10. Fuel injector sight shield cover. Refer to Engine Cover Replacement Service and Repair.
11. Body hinge pillar tie bar-cross car beam.