Transmitter Programming

IMPORTANT: Before entering the programming mode, verify possession of all the transmitters you will be using on the vehicle. Once you program the transmitter, the memory erases. The other transmitters will not be functional until you program the transmitters again. You may program up to 4 transmitters. Perform the following procedure or use a scan tool when adding new transmitters or replacing failed transmitters.

Programming Procedure
1. Turn OFF the ignition switch.
2. Use a fused jumper in order to connect the Data Line Connector terminal 8 (BLK/WHT) to terminal 4 (BLK).
3. Close all of the doors.
4. Turn ON the ignition switch. The door will cycle to lock.
5. Press and hold the following buttons on one of the transmitters for 30 second:
^ LOCK
^ UNLOCK
6. After a 30 second delay the doors will lock and unlock.

IMPORTANT: Do not turn off the ignition. If the switch is turned off, the first transmitter becomes inoperative.

7. In order to program extra transmitters, repeat Step 5.
8. Disconnect the jumper from the DLC.