Oil Level Sensor: Service and Repair

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Raise the vehicle. Refer to Vehicle Lifting in Service Precautions.
3. Drain the engine oil.
4. Disconnect the electrical connector from Engine Oil Level Switch
5. Remove the Engine Oil Level Switch from the oil pan.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.

1. Install the Engine Oil Level Switch.

Tighten
Torque the Engine Oil Level Switch to 17-27 N.m (13-20 lb ft).

2. Lower the vehicle.
3. Add the engine oil to the correct level. For the crankcase oil capacity, refer to Service Precautions.
4. Connect the negative battery cable.