Fuel Pump Pickup Filter: Service and Repair

REMOVAL PROCEDURE

Modular Fuel Sender Assembly:

IMPORTANT: Always maintain cleanliness when servicing fuel system components.

1. Relieve fuel system pressure. Refer to Fuel Pressure Relief Procedure.
2. Remove the fuel sender assembly.
3. Note strainer (3) position for future reference.




4. Support the reservoir with one hand and grasp the strainer with the other hand.
5. Use a screwdriver to pry the strainer ferrule off the reservoir.
6. Discard the strainer.





INSTALLATION PROCEDURE
1. Install the new strainer (4) to the reservoir.
2. Support the reservoir with one hand and grasp the strainer with the other hand twisting the strainer into position.
3. Reinstall the fuel sender assembly.
4. Tighten the fuel fill cap.
5. Reconnect the negative battery cable.
6. Inspect for fuel leaks:
6.1. Turn the ignition switch ON for 2 seconds.
6.2. Turn the ignition switch OFF for 10 seconds.
6.3. Turn the ignition switch ON.
6.4. Check for fuel leaks.
7. Reinstall the fuel injection sight shield.