Adding Customer's Code
1. Turn the ignition to one of the following positions:^ ACC
^ RUN
2. Turn the radio OFF.
IMPORTANT: If SEC is displayed, the theft deterrent is already activated. Remove the old code before you enter a new code.
3. Press the 1 and 4 pushbuttons together for about 6 seconds until the display changes to - - -.
4. Press the HR button.
5. Set the first 2 digits (0-19) of the code with the HR button.
6. Set the next 2 digits (0-99) of the code with the MN button.
IMPORTANT: If - - - is displayed after pressing AM/FM, the customer code has not been entered.
7. Press the AM/FM button in order to enter the code.
8. When REP then 000 are displayed, repeat steps 3-5. Repeating these steps achieves the following results:
^ Confirms the customer code.
^ Activates the theft deterrent feature.
^ After step 5, displays the SEC in order to show the theft deterrent feature has been activated.
The THEFTLOCK TM light flashes once every 2 seconds when the following conditions are present:
^ The ignition is removed.
^ The THEFTLOCK TM is activated.
LOC displays when the following conditions are present:
^ The battery power is cycled.
^ The ignition is applied.
When LOC displays, unlock the system by entering one of the following codes:
^ The customer code
^ The factory backup code