Glove Compartment: Service and Repair

REMOVAL PROCEDURE




1. Open the Instrument Panel (IP) compartment.
2. Release the loop of the damper cord (1) from the IP support.
3. Remove the screws from the IP compartment hinge.




4. Press inward on both sides of the IP compartment housing and rotate down and out of IP.

INSTALLATION PROCEDURE




1. Align the Instrument Panel (IP) compartment housing to the IP.
2. Press inward on both sides of the IP compartment housing and rotate upward and into the IP.
3. Hand tighten the screws to the IP compartment hinge.
4. Align the IP compartment housing to the IP for the proper fit.
5. Install the screws to the IP compartment hinge.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten
Tighten the IP compartment hinge screws to 2 N.m (18 lb in).




6. Open the IP compartment.
7. Connect the loop of the damper cord (1) to the IP support.
8. Close the IP compartment.