75. Engine Front Cover Installation

^ Tools Required
- J 36660 Torque Angle Meter





1. Install the engine front cover gasket.





2. Install the engine front cover. Align the cogs on the crankshaft sprocket with the cogs on the oil pump in the engine front cover.
3. Apply sealant GM P/N 12346004 or equivalent to the engine front cover bolt threads.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the engine front cover bolts.
Tighten the engine front cover bolts to 20 Nm (15 ft. lbs.). Use the J 36660 to tighten the engine front cover bolts an additional 40 degrees.
5. Install the oil pan to engine front cover bolts.
Tighten the oil pan bolts to 14 Nm (125 inch lbs.).
6. Install the oil filter.
Tighten the oil filter to 19 Nm (14 ft. lbs.).





7. Install the crankshaft position sensor.
Tighten the crankshaft position sensor studs to 30 Nm (22 ft. lbs.).





8. Install the crankshaft position sensor shield.