Service Bay Test

Service Bay Tests are included on the scan tool for some systems depending upon vehicle make and model. They may be used to test certain systems and reset the System Status to Complete.

IMPORTANT: Ensure the vehicle meets the following requirements before performing the EVAP Service Bay Test. Failure to meet the necessary requirements may cause inaccurate test results.

The EVAP Service Bay Test can be performed when the vehicle meets the following conditions:
^ The Powertrain OBD System Check has been performed ensuring no DTC's are set.
^ Battery voltage is between 5 and 18 volts.
^ Fuel level is between 15% and 85% approximately 1/4 to 3/4 full.
^ The key ON engine temperature is between 5°C (40°F) and 70°C (158°F).
^ The IM Ready Flag must not be on.
^ Startup Intake air temperature is between 4°C (30°F) and 30°C (86°F).
^ VSS is less than 3 mph.
^ TP sensor is less than 2%.
^ BARO is greater than 75 kPa.

Follow the instructions on the scan tool after ensuring the above conditions have been met.

If any of the above conditions are not met upon activating the Service Bay Test, exit and run the test when conditions are met.