Enabling the SIR System

1. Remove the key from the ignition switch.

2. Connect the passenger yellow 2-way connector located to the right of the steering column.





3. Install the Connector Position Assurance (CPA) to the passenger yellow 2-way connector located to the right of the steering column.





4. Connect the driver yellow 2-way connector located at the base of the steering column.





5. Install the Connector Position Assurance (CPA) to the driver yellow 2-way connector located at the base of the steering column.





6. Install the left instrument panel insulator.

7. Install the SIR fuse to the fuse block.





8. Install the right Instrument Panel Access Hole Cover

9. Staying well away from both air bags, turn the ignition switch to the RUN position.

9.1. The AIR BAG warning lamp will flash seven times.

9.2. The AIR BAG warning lamp will then turn OFF.

10. Perform the SIR Diagnostic System Check if the AIR BAG warning lamp does not operate as described.