Steering Column Trim Covers - Assemble

ASSEMBLY PROCEDURE

- Tools Required
- J 41352 Modular Column Holding Fixture
- J 42640 Steering Column Anti Rotation Pin





1. Install the upper shroud (2) onto the steering column.

NOTICE: Refer to Fastener Notice in Service Precautions.

2. Screw the 2 TORX(R) head screws (1) into the upper shroud (2).
- Tighten the 2 TORX(R) head screws to 1.5 Nm (13 inch lbs.).





3. Install the shift lever seal (2) onto the shift lever assembly (4).
4. Install the shift lever assembly (4) onto the upper shroud (1).
5. Install the shift lever screw (3) into the shift lever assembly (4).
- Tighten the shift lever screw to 1.5 Nm (13 inch lbs.).

6. Slide the shift lever seal (2) down the shift lever (4).
7. The shift lever seal must seat in the shrouds.





8. Install the shroud protector (1) onto the lower shroud (2).





9. Install the lower shroud onto the upper shroud.
10. Match the tab slots on the lower shroud with the locking tabs on the upper shroud.
11. Tilt the lower shroud up.
12. Slide the lower shroud forward until the locking tabs snap into the tab slots.





13. Screw the 2 pan head tapping screws (1) into the lower shroud (2).
- Tighten the 2 pan head tapping screws to 3.5 Nm (31 inch lbs.).

14. Install the tilt lever into the lower shroud (2).





15. Remove J 42640 from the lower shroud of the steering column.
16. Remove the steering column and J 41352 from the vise.