Turn Signal & Multifunction Switch - Assemble

ASSEMBLY PROCEDURE

IMPORTANT: The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.





1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.

NOTICE: Refer to Fastener Notice in Service Precautions.

2. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction switch assembly (2).
- Tighten the 2 pan head tapping screws to 7 Nm (62 inch lbs.).





3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).
4. Reconnect the turn signal and multifunction switch assembly connector to the SIR coil assembly connector.





5. Attach the wire harness assembly (1) to the steering column with new wire harness straps (2).
6. Install the upper and lower shrouds.