Shift Lever

REMOVAL PROCEDURE





1. Roll back the automatic transmission control lever seal from the selector lever.
2. Remove the screw from the automatic transmission control lever.
3. Remove the automatic transmission control lever.

INSTALLATION PROCEDURE
1. Install the automatic transmission control lever.

NOTICE: Refer to Fastener Notice in Service Precautions.


2. Install the screw to the automatic transmission control lever.
- Tighten the screw to 20 Nm (14 ft. lbs.).

3. Install the automatic transmission control lever seal.
4. Verify that there is a positive shift gate feel in all positions, after the lever is installed.