Body Control Module (BCM) - Programming - Setup - New

TOOLS REQUIRED:
Scan Tool

IMPORTANT:
^ Read the BCM set-up procedures carefully and completely.
^ The BCM will not function properly if the Setup New BCM Procedure is not performed.
^ Perform the Theft Deterrent Re-Learn procedure after successfully finishing the Setup New BCM Procedure. If the Theft Deterrent Re-Learn procedure is not performed after a BCM replacement, the following conditions may occur:
- The vehicle will not be protected against theft by the PASS-Key II system.
- The engine will not start.

1. Connect a Scan Tool scan tool to the Data Link Connector in the vehicle.
2. Input all of the required data when prompted by the Scan Tool.
3. Turn the ignition switch to the RUN position.
4. Select SPECIAL FUNCTIONS at the MAIN MENU screen.
5. Select SETUP NEW BCM at the SPECIAL FUNCTION MAIN MENU screen.
6. Perform the Theft Deterrent Re-Learn procedure after successfully finishing the Setup New BCM Procedure. If the Theft Deterrent Re-Learn procedure is not performed after a BCM replacement, the following conditions may occur:
^ The vehicle will not be protected against theft by the PASS-Key II system.
^ The engine will not crank or start.