Body Control Module (BCM) - Re-Learn Using Techline Terminal & Tech 2 Scan Tool

1. Connect the Scan Tool scan tool to the DLC on the vehicle.
2. At the Scan Tool scan tool main menu, select SERVICE PROGRAMMING.
3. Enter the requested information.
4. Select REQUEST INFO.
5. Disconnect the Scan Tool scan tool from the vehicle.
6. Connect the Scan Tool scan tool to the Techline terminal.
7. Select SERVICE PROGRAMMING SYSTEM (SPS).
8. Select TERMINAL TO TECH 2 PROGRAMMING.
9. Select DONE.
10. Follow the instructions on the Techline terminal to Handheld Communications Setup screen.
11. Select THEFT MODULE RE-LEARN.
12. Select PROGRAM at the summary screen. The terminal will download information to the Scan Tool scan tool.
13. Disconnect the Scan Tool scan tool from the Techline terminal.
14. Connect the Scan Tool scan tool to the DLC on the vehicle.
15. At the Scan Tool scan tool main menu, select SERVICE PROGRAMMING.
16. Answer the question prompted by the Scan Tool scan tool.
17. Select RE-LEARN.
18. The Powertrain Control Module (PCM) and the BCM will be prepared for re-learn.
19. A security timer will turn on for approximately 10 minutes. During the 10 minute wait period, ensure that the Scan Tool scan tool remains connected to the vehicle.
20. Turn the ignition switch to the OFF position when the PCM and the BCM are prepared to re-learn.
21. Turn the ignition switch to the START position. The engine should start when the ignition key is turned to the START position.
22. Disconnect the Scan Tool scan tool from the DLC.