113. Case Side Cover and Gaskets Assemble

^ Tools Required
- J 36850 Assembly Lubricant (or equivalent)





1. Inspect the case side cover (53) for the following conditions:
^ Damaged or porous gasket seating surfaces
^ Damaged or porous casting surfaces
^ Damaged or stripped bolt holes
2. Inspect the case side cover gaskets (54, 59) for damage. The gaskets are reusable if they are NOT damaged.





3. Assemble the case side cover inner gasket (59) to the case side cover (53). Use J 36850 or equivalent to retain the gasket in position.
4. Install the case side cover gasket (54) and case side cover (53) onto the case. Make sure the gaskets and electrical connector are positioned correctly.





5. Install case side cover bolt (56) and one side cover to case stud bolt (58) in the locations shown. These bolts will properly locate the case side cover and gasket to the case.

Notice: Refer to Fastener Notice in Service Precautions.

6. Install the remaining bolts as indicated:
^ Nine case side cover bolts (56)
^ Four side cover Torx(R) head bolts (57)
^ Four side cover to case stud bolts (58)
^ Tighten all bolts to 25 Nm (118 ft. lbs.).