119. Accumulator Assembly, 2-1 Band Servo Assemble

1. Install the 2-1 manual band servo cover seal (105) into the case. Lubricate the 2-1 manual band servo cover seal (105) with automatic transmission fluid.

Important: Be careful not to damage the 2-1 manual band servo exhaust screen (115) on installation.

2. Install the 2-1 manual band servo assembly (106-116) into the case. Make sure that the 2-1 manual band servo pin engages the 2-1 manual band assembly.





3. Install the accumulator (132-140) and 2-1 manual band servo cover assembly (1104) into the case.
4. Install the lube oil pipe and washer assembly (130) through the case and into the lube hole in the differential carrier internal gear.
5. Use a screwdriver in order to lock the lube oil pipe retainer (129) into the case.

Notice: Refer to Fastener Notice in Service Precautions.

6. Install the three 2-1 manual band servo cover bolts (103).
^ Tighten the bolts to 25 Nm (18 ft. lbs.).
7. Install the four accumulator cover bolts (131).
^ Tighten the bolts to 12 Nm (106 inch lbs.).