126. Torque Converter Inspection

^ Tools Required
- J 8001 Dial Indicator Set
- J 26900-13 Magnetic Indicator Base
- J 35138 Torque Converter End Play Checking Tool





1. Position the torque converter (1) on the bench with the flywheel lugs facing down.
2. Install J 26900-13, J 35138, and J 8001 onto the torque converter (1).
3. Set the dial indicator to 0.
4. Lift J 35138 and note the dial indicator reading:
^ The torque converter end play should be 0.5 mm (0.020 inch) or less
^ If the end play is too high, replace the torque converter (1)





5. Inspect and replace the torque converter (1) for the following conditions:
^ Overheated (torque converter will be blue in color)
^ Leaking at the weld areas
^ A damaged torque converter pilot
^ Evidence of metal particles in the converter, the oil cooler, or the cooler pipes
^ A damaged torque converter stator, a damaged pump, or a damaged turbine
^ A damaged or worn torque converter bushing (2)
^ Contaminated automatic transmission fluid due to engine coolant
6. Inspect the torque converter for stripped bolt hole threads. If found, repair the torque converter.