Rear Side Door Window Replacement

REMOVAL PROCEDURE




1. Remove the trim panel.
2. Remove the water deflector.
3. Remove the inner energy absorber.
4. Remove the inner sealing strip.
5. Remove the outer belt sealing strip.
6. Remove the rear door frame molding.
7. Remove the window mounting bolts (1,2).
8. Remove the window.

INSTALLATION PROCEDURE




1. Position the window between the inner and the outer panels.
2. Point the lower front corner of the window down.
3. Pass the window through the belt opening. Align the edges with the door window weatherstrip.
4. Turn the window to the horizontal position. Align the holes in the window with the holes in the regulator. Ensure that both sealing lips on the front door outer belt sealing strip are not rolled over and pointing downward. If this condition is present, the window will not raise properly.

NOTE: Refer to Fastener Notice in Service Precautions.

5. Install the window to regulator bolts (1,2). Tighten the forward bolt first.

Tighten
Tighten the forward window to regulator bolt to 10 N.m (89 lb in).

6. Tighten the rearward bolt second.

Tighten
Tighten the rearward window to regulator bolt to 10 N.m (89 lb in).

7. Install the outer belt sealing strip.
8. Install the inner sealing strip.
9. Install the inner energy absorber.
10. Install the water deflector.
11. Install the trim panel.