Washer Solvent Container Replacement

REMOVAL PROCEDURE




1. Remove the screw from the tube and the vehicle.
2. Remove the tube with the seal from the washer solvent container.
3. Remove the seal from the tube.




4. Remove the front fender liner.
5. Disconnect the electrical connector and the hose from the washer pump.
6. Remove three screws and the washer solvent container from the vehicle.
7. Disconnect the connector from the washer solvent level sensor.
8. Remove two screws and the bracket from the washer solvent container.
9. Remove the solvent level sensor and seal.
10. Remove the washer pump and grommet.

INSTALLATION PROCEDURE




1. Install the washer pump and the grommet.
2. Install the solvent level sensor and seal.

NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the bracket with two screws on the washer solvent container.

Tighten
Tighten the screws to 7 N.m (62 lb in).

4. Connect the electrical connector to the washer solvent level sensor.
5. Install the washer solvent container on the vehicle with three screws.

Tighten
Tighten the screws to 5 N.m (44 lb in).

6. Connect the electrical connector and the hose to the washer pump.
7. Install the front fender liner.




8. Install the seal onto the tube.
9. Install the tube with the seal on the washer solvent container.
10. Install the tube on the vehicle with the screw.

Tighten
Tighten the screw to 5 N.m (44 lb in).