Ignition & Key Alarm Switch - Assemble

Assembly Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the ignition and key alarm switch assembly (2) and secure by using 2 tapping screws (3).
- Tighten the screws to 7 Nm (62 inch lbs.).
2. Install the ignition and key alarm connector (1) onto the lock module assembly (4).





3. Connect the coded key controller.
4. Connect the fused jumper assembly connector.





5. Slide the 2 connector of the turn signal and multifunction switch assembly (2) onto the bulk head connector (1).





6. Install the control coded key (2) onto the lock module assembly (1).
7. Install the shift lever and shift lever seal assembly. Refer to Shift Lever - Assemble - Off Vehicle.